Tungsten steel CNC tool is a kind of high performance tool, which is widely used in CNC machine tool processing. The operation of tungsten steel CNC tool is simple, but it needs to be operated in strict accordance with the operating procedures to ensure the service life and processing quality of the tool. The following are the steps of tungsten steel CNC tool operation:
1. Install the tool: Before installing the tungsten steel CNC tool, first check whether the tool is intact, whether the tip is sharp, and whether the handle is loose. Then select the appropriate tool according to the processing materials and processing requirements, and load the tool into the tool holder.
2. Install the tool: Insert the tool into the tool holder, and then clamp the tool holder with a wrench or wrench to ensure that the tool is firmly installed and will not be offset or thrown.
3. Set parameters: On CNC machine tools, the corresponding processing parameters need to be set according to the processing requirements, including speed, feed speed, cutting depth, etc. These parameters will directly affect the service life and processing quality of the tool, so it must be adjusted according to the actual situation.
4. Start the machine tool: After setting the processing parameters, you can start the CNC machine tool for processing operation. During the operation of the machine tool, it is necessary to always pay attention to the running state of the tool, and immediately stop the machine for inspection once there is an abnormal situation.
5. Complete the processing: according to the processing requirements of the processing operation, to ensure that the tool in the right conditions to complete the processing task. In the process of processing, it is necessary to clean up the chips in time to avoid excessive cutting resistance during the cutting process leading to tool damage.
6. Check the tool: After each processing, check the wear of the tool and whether the tip is blunted. If the knife is found to have wear or blunt tip, it should be replaced or trimmed in time to avoid affecting the quality of the next processing.
Through the above steps, we can correctly operate the tungsten steel CNC tool to ensure the service life and processing quality of the tool. At the same time, pay attention to safe operation to avoid accidents. I hope you found the above helpful.
Post time: Oct-14-2024